48
01
[
SQL
]
Function: Squelch Level Setting.
Available Values: 0 ~ 8
Default Setting: 6
Select a setting for this Menu item which just silences
the receiver when no signal is present. Use the lowest
setting which will keep the receiver quiet between in-
coming transmissions.
02
[
MCLR
]
Function: Memory Channel Clear (“MR” memory
only).
To clear a Memory channel:
Select the Menu Item
MCLR
.
Press down on the
VOLUME
knob, then rotate the
DIAL
selector knob to recall the memory channel to
be erased.
Press down on the
VOLUME
knob to clear the
Memory channel (the Memory channel number will
return to “
001
”).
Important Notice: An “erased” channel cannot be re-
stored, and “
CH-001
” cannot be erased, as it is used for
“Priority Channel” operation.
menu
(
“
set”
)
mode
03
[
RESM
]
Function: Scan-Resume Mode Setting.
Available Values: 5S/CAR
Default Setting: 5S
“5S” (5-Second Pause) mode: the scanner will halt
for ve seconds only, after which scanning will resume
(whether or not the other station is still transmitting).
“CAR” (Carrier Drop) mode: the scanner will remain
halted for as long as there is a carrier present on the
channel; after the carrier drops at the end of the other
station’s transmission, the scanning will resume.
04
[
SCNL
]
Function: Scan Lamp On/Off (while paused).
Available Values: on/oFF
Default Setting: on
If you set this function to “on,” the lamp will be illumi-
nated whenever the scanner pauses. The lamp will go off
automatically when scanning resumes.
To Next Page
Loading...
