31
To label a memory with an alpha/numeric name,
the next step is to use the
DIAL
selector knob to
select any of the 48 available characters (including
letters, numbers, and special symbols). When the
desired rst character appears,
press downward on
the
VOLUME
knob
momentarily to move on to the
next character.
Select succeeding characters in the same manner,
press downward on the
VOLUME
knob
momen-
tarily after each selection.
After entering the entire name (eight characters
maximum), press the
[
MW
(
SPL-W
)]
key for 2 sec-
onds to save all data for the channel and exit.
Note: If you have transferred a Weather Channel di-
rectly to memory, the “WX-001 ~ WX-010” labels
utilize the alphanumeric memory, and other labels may
not be stored. But if you go to the VFO mode, and dial
up or key in the weather station’s frequency manually,
you may then store the frequency and a custom alpha-
numeric label yourself.
Recalling the Memories
press downward on the
VOLUME
knob
, repeatedly
if necessary, until “
-
MR
-
” (Memory Recall) ap-
pears on the display. In the MR mode, you will see
“
CH-
” and the previously selected channel number
appearing on the LCD.
Rotate the
DIAL
selector knob to select the desired
memory channel.
You may change the title structure of the Memory
display type among:
1. Channel Indication (sequential Channel Num-
ber, e.g.
CH-001
,
CH-002
, etc.);
2. Frequency Indication (e.g.
122.500
); or
3. Alphanumeric Label (e.g.
LAX FSS
).
To change the Memory display title, press the
[ ( )]
key repeatedly, if necessary, until you
get the desired display title structure.
To exit the Memory mode, press the
DIAL
selector
knob three times to return to the VFO mode.
Note: In either the “MR” or the “Book” Memory mode,
an easy way to recall memories is to key in the memory
channel number, then press the
[
SCAN
(
DW
)]
key. For
example, to recall memory channel #14, press
[
1
]
[
4
]
[
SCAN
(
DW
)]
.
memory operatIon
To Next Page
Loading...
