Yaesu FTA-310 - CPU Resetting

FTA-310 OperATing MAnuAl
43
programmIng tHe user Key assIgnments
Default
FTA-310
functions have been assigned to “Pri-
mary” (press) and “Third” (press and hold in) function
of the front panel’s
[
USER
]
key at the factory. These
may be changed by the user, if you wish to utilize an-
other function on this key.
To program the function assigned to the
[
USER
]
key:

Press the
[
F
]
key, then press downward on the
VOL-
UME
knob to activate the Menu (“SET”) mode.

Rotate the
DIAL
knob to select the Menu Item to be
congured #18 “
KEY1
” which is tied to the primary
function, or #19 “
KEY2
” which is tied to the third
function.

Press downward on the
VOLUME
knob momentari-
ly, then rotate the
DIAL
knob to select the function
you wish to assign to the
[
USER
]
key.

When you have made your selection, press down-
ward on the
VOLUME
knob to save the new setting,
then press the PTT switch to exit the Menu (“SET”)
mode.
The available selections include:
no
/
ANL
/
PA
/
EQ
ANL
: Receiver Automatic Noise Limiter (on)
PA
: Public Address Mode (see page 26)
PIT
: Pitch Control (see page 24)
no
: Disables the key