Yaesu FTA-310 - Battery Charging

FTA-310 OperATing MAnuAl
12
Battery Charging
It is necessary to charge the Ni-MH battery fully before
its rst use. Follow these procedures:

Install the supplied
FNB-83
Ni-MH battery pack
onto the transceiver. Ensure that the transceiver is
switched off.
Use for PA-48/CD-28
1. Insert the cable plug into the jack located on the
right side of the
CD-28
Charging Cradle then plug
the
PA-48
Battery Charger into the AC line outlet.
2. Insert the transceiver and battery pack into the
CD-
28
; the antenna jack should be at the left side when
viewing the charger from the front.
3. If the transceiver and battery pack are inserted
co rr ec tly, t he R ED
indicator on the
CD-
28
will glow. A fully-
discharged pack will
be charged completely
in 12 hours.
Use for CD-59
1. Insert the cigarette lighter plug into the cigarette
lighter socket (DC 11 V ~ 16 V).
2. Insert the transceiver and battery pack into the
CD-
59
; the antenna jack should be at the left side when
viewing the charger from the front.
3. If the transceiver and battery pack are inserted cor-
rectly, the RED indicator on the
CD-59
will glow. A
fully-discharged pack will be charged completely in
15 hours.
BeFore you BegIn
CD-28
PA-48
CD-59
DC 11 V ~ 16 V