Figure 5. Switch Position Mode Chart
Changing Mode Setting
NOTE: Mode settings can be checked by connecting
the battery charger to a 120V AC power source and
watching the LED display while connected to the
battery, reference Table 2 for LED display of mode
setting. If the battery voltage is below 12V, no lights
illuminate.
Modes are set by the sequence of the dip switches.
Tampering with the Charging Mode Label voids
warranty. For the Lithium-Ion battery, the charger
should always be set to Mode 15.
2240 YRM 1890 Charging and Troubleshooting
5
To Next Page
Loading...