DTC 30086
LowBatt
POSSIBLE CAUSE
A. LOW BATTERY CONDITION
B. CONTROLLER WIRING FAULT
C. FAULTY CONTROLLER
NOTE
Please refer to the end of this procedure for supporting diagrams.
COMPONENT OPERATIONAL CHECK
NOTE: Always check battery condition and state of charge before performing electrical troubleshooting. A faulty
or low charged battery will cause electrical features to not operate as designed and give incorrect readings while
performing electrical tests.
PROCEDURE OR ACTION:
1. Conduct a visual inspection of all connectors/wiring associated with the fault code.
Are any faults detected/observed?
YES: Repair/replace connector or wiring associated with faults found. Refer to the appropriate Electrical
System YRM.
NO: Proceed to Step 2.
2. Re-key the vehicle.
Is the code still present?
YES: Disconnect battery and discharge the capacitor. Connect battery and re-key the vehicle prior to perform-
ing Cause A.
NO: Problem may be intermittent.
Diagnostic Trouble Codes ELECTRICAL SYSTEM
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
9030-20-38
To Next Page
Loading...