Figure 5. Switch Position Mode Chart
Mode Setting Check
NOTE: Mode settings can be checked by connecting
the battery charger to a power source and watching
the LED display while connected to the battery, refer-
ence Table 2 for LED display of mode setting. If the
battery voltage is below 12V, no lights illuminate.
Mode setting information is only displayed for four
seconds after initial power source is connected.
Modes are set by the sequence of the mode switches.
Tampering with the Charging Mode Label voids war-
ranty.
NOTE: If the charger has been Field Reprogrammed,
during first time charger is used, startup time can take
up to 10 minutes. The LEDs will not flash and the
charger will appear to be frozen. Do not unplug the
charger as it rebuilds internal database information.
Table 2. LED Charge Mode Indicator
MODE SETTING LED 1 LED 2 LED 3 LED 4 LED 5
1 Off Off Off Off Flashing
2 Off Off Off Flashing Off
4 Off Off Flashing Off Off
5 Off Off Flashing Off Flashing
13 Off Flashing Flashing Off Flashing
15 Off Flashing Flashing Flashing Flashing
16 Flashing Off Off Off Off
2200 YRM 2030
AccuSense
®
Q-Series Charger
3
To Next Page
Loading...