P/N - - Rev AYRL LPBINSTL FUL
25
Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except Master) codePIN
access. When attempting to enter a code while the unit is in Lockout, the locked padlock will appear on the screen.RED
Audio Mode: Enable (1) Disable (3)The audio setting for code verification is set to by default; otherwise it can be set to forPIN
quiet areas.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it will automatically re-lock after thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status (Locked) of lock and can be enabled or disabled in
the (Main Menu selection #3).Advanced Lock Settings
Low Battery: When battery power is low, the Low Battery Warning indicator flashes . If battery power is completely lost, useRED
the cylinder key override.
Master Code: It must be created prior toPIN The Master code is used for programming and for feature settings.PIN
programming the lock. The Master code will also operate (unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes available thru the Main Menu (7) and
allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-lock duration or
when Automatic Re-lock is disabled). When One-Touch Re-lock is in use any valid code will re-lock the lock.not (disabled), PIN
Shutdown Time: The unit will shutdown (flashing ) for sixty (60) seconds and not allow operation after the wrong code entryRED
limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User Code:PIN The User code operates the lock. Maximum number of user codes is 250 with Network Module; without Network
Module, maximum is 25 user codes. Note: When deleting User code(s), screen will display User Number (not code) beingPIN PIN
deleted.
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid code, the unit will shut down and not allowPIN
operation for sixty (60) seconds.
To Next Page
Loading...
