20
P/N 80-9150-0080-010 (10-17)
Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except
Master) code access. When attempting to enter a code while the unit is in Lockout, the locked padlockPIN RED
will appear on the screen. (Main Menu selection #6.)
Automatic Re-lock Time: After a successful unlock, the unit will re-lock automatically after 5 seconds or for a
duration selected in the (Main Menu selection #3 then #1).Advanced Lock Settings
Language Setting Mode: Choose English (1), Spanish (2) or French (3) for the lock's voice prompts. (Main
Menu selection #5.)
Low Battery: When battery power is low, the Low Battery Warning indicator flashes . If battery power isRED
completely lost, use the 9Volt battery override. To use the 9V battery override apply 9V battery, in either
direction, to terminals on the touchscreen for backup power option. Activate the touchscreen and enter your pin
code to unlock the door.
Master Code: It must be createdPIN The Master code is used for programming and for feature settings.PIN
prior to programming the lock. The Master code will also operate (unlock/lock) the lock.
Network Module Setting: With the optional Network Module installed, this setting becomes available (Main
Menu selection #7) and allows the lock to connect with a network controller.
One Touch Locking: When the unit is unlocked, activating the touchscreen will lock the unit (during Automatic
Re-lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is in use anynot (disabled),
valid code will re-lock the lock. (Main Menu selection #3 then #3.)PIN
Privacy Button to Lock Door: If Automatic Re-lock is disabled, a short 1 second press of this button will lock the
door.
Privacy Mode: With optional Door Position Switch installed, Privacy Mode enabled thru Menu Mode and door
closed, all keypad functions can be disabled with a 3 second press of the Privacy Button. Privacy Mode is
disabled by default. Enable Privacy Mode thru Main Menu selection #3 then #4. With door closed, press and
hold the privacy button until voice prompt indicates Privacy Mode is enabled. Privacy Mode duration ends when
door is opened and voice prompt indicates Privacy Mode is disabled.
Shut Down Time: The unit will shut down for sixty (60) seconds and not allow operation after the wrong code
entry limit (5 attempts) has been met. When the unit is in Shut down, the keypad will be flashing.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User Code:PIN The User code operates the lock. Maximum number of user codes is 500.
Volume Setting Mode: (1)The volume setting for code verification is set to by default; otherwise itPIN HIGH
can be set to or for quiet areas. (Main Menu selection #4.)Low (2) Silent (3)
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid code, the unit will shutPIN
down and not allow operation. When the unit is in Shut Down, the keypad will be flashing.
To Next Page
Loading...
Need help?
General
