Yamaha 02R Version 2 - Digital I;O Card-TDIF-1 (CD8-TDII)

234 Installing Options
02R User’s Guide
Digital I/O Card—TDIF-1 (CD8-TDII)
The TDIF-1 digital I/O card (CD8-TDII) is used to connect TASCAM
TDIF-1 modular digital multitrack recorders such as the DA-88 to the 02R.
Installing the CD8-TDII
The TDIF-1 digital I/O card (CD8-TDII) is a single slot card. For installation
instructions, see “Single Slot Cards” on page 221 of the User’s Guide.
1. Connect the TASCAM DA-88 modular digital multitrack recorder
to the 02R using the appropriate connectors.
Use the special cable to plug the connector of the CD8-AT to the
DIGITAL I/O connector of the TASCAM DA-88 recorder.
If you have installed more than one CD8-TDII in the 02R and have
more than one TASCAM DA-88 recorder, connect it in the same
manner as the first unit.
The TASCAM DA-88 recorder is equipped with a WORD SYNC OUT
connector. Use a BNC cable to plug it into the WORD CLOCK—IN
connector on the back of the 02R.
If you are using more than one TASCAM DA-88 recorder, make the
first unit the wordclock master. There are SYNC IN/SYNC OUT
connectors on the DA-88 recorders that allow them to run together.
DA-38s can not be used as wordclock master, because they do not have
a SYNC OUT connector.
02R(Wordclockslave)
75switch＝ON
CD8-TD CD8-TD
SLOT 1 SLOT 2
WORD
SYNC OUT
DIGITAL
I/O
DIGITAL
I/O
WORD
CLOCK IN
TASCAM DA-88/DA-38
(Word clock slave)
TASCAM DA-88
(Word clock Master)
SYNC
IN
SYNC
OUT