Yamaha 02R Version 2 - Options

Specifications 249
02R User’s Guide
Options
AD/DA I/O Card Specifications
Analog Input
Analog Output
Digital I/O Card Specifications
Digital Input/Output
*1 Sensitivity is the lowest level that will produce an output of +4 dB (1.23V) or the nominal output level when the unit
is set to maximum gain. (All faders and level controls are maximum position.)
*2 CH INPUT phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
✳ In these specifications, when dB represents are specific voltage, 0 dB is referenced to 0.775 volts RMS.
✳ In these specifications, when dBV represents are specific voltage, 0 dBV is referenced to 1 volts RMS.
*1 CH OUTPUT phone jacks are balanced. (Tip=HOT, Ring=COLD, Sleeve=GND)
✳ In these specifications, when dB represents are specific voltage, 0 dB is referenced to 0.775 volts RMS.
✳ In these specifications, when dBV represents are specific voltage, 0 dBV is referenced to 1 volts RMS.
Input
connections
GAIN
Actual load
impedance
For use
with nom-
inal
Input level
Mixer
connector
Sensitivity
*1
Nominal
Max.
before clip
INPUT 1
through 8
+4
10kΩ 600Ω lines
–6 dB
(388mV)
+4 dB
(1.23mV)
+24 dB
(12.3mV)
Phone Jack
(TRS)
*2
–10
–20 dBV
(100mV)
–10 dBV
(316mV)
+10 dBV
(3.16V)
Output connections GAIN
Actual source
impedance
For use
with nom-
inal
Output level
Mixer connector
Nominal
Max be-
fore clip
OUTPUT 1 through 8
+4
150Ω 10kΩ lines
+4 dB
(1.23mV)
+24 dB
(12.3mV)
Phone Jack
(TRS)
*1
–10
–10 dBV
(316mV)
+10 dBV
(3.16V)
Input/Output Format Level Mixer connector
DA88/DA38 (BUS/DIRECT OUT, TAPE IN) TDIF-1 C-MOS D-SUB 25PIN
ADAT (BUS/DIRECT OUT, TAPE IN) ADAT OPTICAL
AES/EBU (BUS/DIRECT OUT, TAPE IN) AES/EBU RS422
XLR-3-31 type (INPUT)
XLR-3-32 type (OUTPUT)
D-SUB 25PIN
YAMAHA (BUS/DIRECT OUT, TAPE IN) YAMAHA RS422 D-SUB 25PIN
CASCADE (BUS/DIRECT OUT, TAPE IN) YAMAHA RS422 D-SUB 25PIN