Yamaha 03D - Page 140

138 Chapter 13—Onboard Effects
03D—Owner’s Manual
DELAY+REV
DELAY->REV
Parameter Range Description
DLY L 0.1–1000.0 ms Delay time of the L channel.
DLY R 0.1–1000.0 ms Delay time of the R channel.
FB.DLY 0.1–1000.0 ms Feedback delay time.
FB.GAIN –99 to +99% Feedback amount.
HI.RATIO 0.1–1.0
High frequency portion of the feedback, expressed as a
ratio relative to FB.GAIN.
REV.TIME 0.3–99.0 s Length of reverberation.
INI.DLY 0.1–500.0 ms
Delay time until the early reflections of the reverb are
heard.
HI.RATIO 0.1–1.0
Length of reverberation for the high frequencies, expressed
as a ratio relative to REV.TIME.
DIFF. 0–10 Left/right spread of the reverb.
DENSITY 0–100% Density of the reverb.
HPF
THRU,21 Hz–8.0
kHz
Cutoff frequency of the high pass filter.
LPF
50 Hz–16.0 kHz,
THRU
Cutoff frequency of the low pass filter.
REV.BAL 0–100%
Balance of the reverb and delay. 0 is only delay, 100 is only
reverb.
Parameter Range Description
DLY L 0.1–1000.0 ms Delay time of the L channel.
DLY R 0.1–1000.0 ms Delay time of the R channel.
FB.DLY 0.1–1000.0 ms Feedback delay time.
FB.GAIN –99 to +99% Feedback amount.
HI.RATIO 0.1–1.0
High frequency portion of the feedback, expressed as a
ratio relative to FB.GAIN.
REV.TIME 0.3–99.0 s Length of reverberation.
INI.DLY 0.1–500.0 ms
Delay time until the early reflections of the reverb are
heard.
HI.RATIO 0.1–1.0
Length of reverberation for the high frequencies, expressed
as a ratio relative to REV.TIME.
DIFF. 0–10 Left/right spread of the reverb.
DENSITY 0–100% Density of the reverb.
HPF
THRU,21 Hz–8.0
kHz
Cutoff frequency of the high pass filter.
LPF
50 Hz–16.0 kHz,
THRU
Cutoff frequency of the low pass filter.
REV.BAL 0–100%
Balance between the delay and the delayed reverb. 0 is
only delay.