Yamaha 03D - Page 141

Effects Parameters 139
03D—Owner’s Manual
MONODELAY->REV
AMP SIMULATE
1. STK-M1, STK-M2, THRASH, MIDBOOST, CMB-PG, CMB-VR, CMB-DX, CMB-TWN,
MINIAMP, FLAT
2. DST1, DST2, OVD1, OVD2, CRN
Parameter Range Description
DELAY 0.1–1000.0 ms Delay time.
FB.DLY 0.1–1000.0 ms Feedback delay time.
FB.GAIN -99 to +99% Feedback amount.
HI.RATIO 0.1–1.0
High frequency portion of the feedback, expressed as a
ratio relative to FB.GAIN.
REV.TIME 0.3–99.0 s Length of reverberation.
INI.DLY 0.1–500.0 ms
Delay time until the early reflections of the reverb are
heard.
HI.RATIO 0.1–1.0
Length of reverberation for the high frequencies, expressed
as a ratio relative to REV.TIME.
DIFF. 0–10 Left/right spread of the reverb.
DENSITY 0–100% Density of the reverb.
HPF
THRU,21 Hz–8.0
kHz
Cutoff frequency of the high pass filter.
LPF
50 Hz–16.0 kHz,
THRU
Cutoff frequency of the low pass filter.
REV.BAL 0–100%
Balance between the delay and the delayed reverb. 0 is
only delay.
Parameter Range Description
AMP TYPE
1
Select the type of amp.
DST TYPE
2
Select the type of distortion.
N.GATE 0–20 Amount of noise gating.
DRIVE 0–100 Depth of distortion.
MASTER 0–100 Master level control.
CAB DPT 0–100% Amount of speaker simulation.
BASS 0–100 Low range tone control.
MIDDLE 0–100 Mid range tone control.
TREBLE 0–100 High range tone control.
EQ F 99 Hz–8.0 kHz Frequency of the parametric equalizer.
EQ G –12 to +12 dB Gain of the parametric equalizer.
EQ Q 10.0–0.40 Bandwidth of the parametric equalizer.