Yamaha CL1 - Page 72

CL Editor Owner’s Manual
72
4 LINK PARAMETER
This section enables you to select the parameters to interlock.
The HA, FADER, DIGITAL GAIN, and DELAY parameters will maintain level differences between linked
channels.
5 SEND PARAMETER
Specify the link status for each MIX/MATRIX SEND bus.
HA Head amp gain and phantom power settings
HPF HPF settings
DIGITAL GAIN DIGITAL GAIN settings
EQ Equalizer settings
DYNAMICS1 Dynamics 1 settings
DYNAMICS2 Dynamics 2 settings
INSERT INSERT settings
DIRECT OUT DIRECT OUT settings
MIX SEND Send amount from input channel to MIX bus
MIX ON MIX SEND on/off
MATRIX SEND Send amount from input channel to MATRIX bus
MATRIX ON MATRIX SEND on/off
FADER Fader level value
DCA DCA settings
CH ON Input channel module output on/off
MUTE Mute settings
TO ST TO ST settings
DELAY Delay settings
NOTE