Yamaha CL1 - Output Meter

CL Editor Owner’s Manual
56
3 Input patch
Click the CHANNEL field, and choose one of the following as the signal route that will be
patched to the input channel(s) of the currently selected GEQ module.
The channel name is shown in the boxes immediately below.
4 Input meter
This indicates the level of the signal that is being input to the currently selected GEQ mod-
ule.
5 Output patch
Click the CHANNEL field, and choose one of the following as the signal route that will be
patched to the output channel(s) of the currently selected GEQ module.
The channel name is shown in the boxes immediately below.
6 Output meter
This indicates the level of the signal that is being output from the currently selected GEQ
module.
NONE No assignment
INS MIX 1–24 MIX channel 1–24 insert out
INS MTRX1–8 MATRIX channel 1–8 insert out
INS ST L, INS ST R, INS M(C) Insert-out of STEREO channel L/R or the MONO channel
NONE No assignment
INS MIX 1–24 MIX channel 1–24 insert in
INS MTRX1–8 MATRIX channel 1–8 insert in
INS ST L, INS ST R, INS M(C)
Insert-in of STEREO channel L/R or the MONO channel
3 4
65