CL Editor Owner’s Manual
87
8 DELAY TIME (Delay time knob)
This knob sets the delay time of the output port. Rotate (by dragging) this knob to set the delay time.
9 Ø (Phase) button
Switches the phase of the signal assigned to the output port between normal phase (black) and reverse phase (orange.)
It is not adjustable if the output-port is set to the RECORDER.
0 GAIN knob
Adjusts the gain level for the signal assigned to the output port. To change the value, rotate (by dragging) the knob in
the screen. You can adjust the setting in 0.1 dB steps over a range of –96 to +0 dB. The current value is shown immedi-
ately below the knob.
A Level meter
This meter indicates the level of the signal assigned to the output port.
To Next Page
Loading...
