Sending Bus Outs to the Stereo Out 87
DM2000—Owner’s Manual
Sending Bus Outs to the Stereo Out
Bus Outs can be routed to the Stereo Out buses as follows. Bus Out to Stereo Out settings
can be stored in the Bus to Stereo library, which contains 1 preset memory and 32 user
memories. See “Bus to Stereo Library” on page 143 for more information.
1 Use the SELECTED CHANNEL ROUTING [DISPLAY] button to locate the Bus
to Stereo page.
2 Use the cursor buttons to select the parameters, and use the Parameter
wheel, INC/DEC buttons, and [ENTER] button to set them.
PAN: These controls are used to pan the Bus Out signals between the left and right Stereo
Out buses. The currently selected Pan control can be set to center by pressing [ENTER].
ON/OFF: These buttons are used to turn on and off the Bus Out to Stereo Out routing.
Faders: These faders are used to set the Bus Out to Stereo Out levels. Fader knobs appear
highlighted when faders are set to 0.0 dB.
Viewing Bus Out Settings
Parameter and fader settings for each Bus Out can be viewed and set on the View pages. See
“Viewing Channel Parameter Settings” on page 124 and “Viewing Channel Fader Settings”
on page 125 for more information.
Copying Bus Out Settings
Bus Out settings can be copied to other Bus Outs by using the Channel Copy function. See
“Copying Channel Settings” on page 129 for more information.
Naming Bus Outs
Bus Outs can be named for easy identification. See “Naming Channels” on page 130 for
more information.
To Next Page
Loading...
Need help?
General
