Grouping Input Channel Mutes (ON/OFF) 73
DM2000—Owner’s Manual
Grouping Input Channel Mutes (ON/OFF)
Input Channel Mutes can be grouped, allowing you to mute several Input Channels simul-
taneously. There are eight Input Channel Mute groups: I, J, K, L, M, N, O, and P.
1 Use the DISPLAY ACCESS [GROUP] button to locate the Input Channel Mute
Group pages.
The Mute group parameters for the 96 Input Channels are divided between two pages. The
Input Channel 1–48 Mute Group page is shown below. The layout of the other page is the
same.
2 Use the LAYER buttons to select the Input Channel Layers.
The corresponding Mute Group page and group row is selected as each Input Channel
Layer is selected.
3 Use the Up/Down cursor buttons to select Mute groups I–P.
The selected group is highlighted by a flashing cursor box.
4 Use the [SEL] buttons to add and remove mutes to and from the selected
group.
When an Input Channel is added to a Mute group, its [SEL] button indicator lights up.
ENABLE: These buttons are used to enable and disable the groups.
Mute groups may contain a combination of channels that are on and channels that are off.
To Next Page
Loading...
Need help?
General
