Yamaha DM 2000 - Bus Outs; Patching Bus Outs to Outputs; Routing Input Channels to Bus Outs; Metering Bus Outs

Bus Outs 85
DM2000—Owner’s Manual
9 Bus Outs
Patching Bus Outs to Outputs
Bus Outs can be patched to the Slot Outputs, Omni Outs, or the 2TR Digital Outputs. See
“Output Patching” on page 63 for more information.
Routing Input Channels to Bus Outs
Input Channels can be routed to the Bus Outs. See “Routing Input Channels” on page 75
for more information.
Metering Bus Outs
Bus Out signal levels can be metered on the Meter pages. See “Metering” on page 103 for
more information.
Monitoring Bus Outs
Bus Outs can be assigned to the CONTROL ROOM [ASSIGN 1] or [ASSIGN 2] button for
monitoring. See “Control Room Monitoring” on page 132 for more information.
Attenuating Bus Outs
Bus Out signals can be attenuated pre-EQ. See “Attenuating Signals” on page 106 for more
information.
EQ’ing Bus Outs
Each Bus Out features 4-band parametric EQ. See “Using EQ” on page 107 for more infor-
mation.
Grouping Master EQs
Bus Out EQs can be grouped with the EQs of other Output Channels. See “Grouping Out-
put Channel EQs” on page 110 for more information.
Bus Out Inserts
Internal effects processors and external signal processors can be patched into the Bus Outs
by using the Inserts. See “Using Inserts” on page 111 for more information.
Compressing Bus Outs
Signal dynamics can be controlled by using the Bus Out Compressors. See “Compressing
Channels” on page 113 for more information.
Grouping Master Compressors
Bus Out Compressors can be grouped with the Compressors of other Output Channels. See
“Grouping Output Channel Compressors” on page 116 for more information.