EasyManuals Logo

Yamaha DSP-A2070 User Manual

Yamaha DSP-A2070
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #32 background imageLoading...
Page #32 background image
30
2-2. RECORDING A SOURCE TO AUDIO/VIDEO TAPE
(OR DUBBING FROM A TAPE TO ANOTHER)
1. Set the REC OUT selector to the SOURCE position.
2. Select the source to be recorded.
3. Play the source and increase the setting of the MASTER
VOLUME control to confirm it.
4. Set the tape deck or VCR used for recording to the recording
mode.
NOTE: Composite Video and S Video signals pass independently
through this unit’s video circuits. Therefore, when recording or
dubbing video signals between two video cassette recorders, if your
source VCR is connected to provide only S Video (or only Composite
Video) you can record only a S video (or only a Composite Video)
signal on your second VCR.
Regardless of the setting of the INPUT SELECTOR, when you
set the REC OUT selector to CD, the audio signal from your CD
player can be recorded by your first tape deck. Likewise, when the
REC OUT selector is set to LD, TV/DBS, VCR 2, VCR 3 or AUX,
both the audio and video signals of the selected source can be
recorded by your first VCR.
When using the REC OUT selector for recording as described
above, you may monitor the audio (or the audio and video) signals
being recorded by selecting TAPE 1 (or VCR 1) on the INPUT
SELECTOR. Also, while using the REC OUT selector to make a
recording, you may use the INPUT SELECTOR to play any source.
Moreover, while you are using the REC OUT selector for record-
ing as described above, you may also use any other VCR or tape
deck not selected by the REC OUT selector to record an audio and
video source selected by the INPUT SELECTOR.
NOTE: The audio and video signals from VCR 2 (or VCR 3) are sent
to VCR 1 when the REC OUT selector is set to VCR 2 (or VCR 3).
If the REC OUT selector is set to VCR 2 (or VCR 3), you can not
dub from your first VCR to the second VCR (or the third VCR), even
if VCR 1 is selected by the INPUT SELECTOR.
To dub the audio from your second tape deck to the first one,
depress the TAPE 2 MONITOR switch (and set the INPUT
SELECTOR to any source other than TAPE 1 before beginning to
record).
MASTER
VOLUME
Front panel Remote control
or
VCR 1
VCR 3 PHONO
VCR 2 CD
TV/DBS
AUX
INPUT SELECTOR
TAPE 2
MONITOR
LD
TAPE 1
TUNER
AUX
PHONO
TAPE 1 TUNER CD
VCR 3
VCR 2
VCR 1 TV
/
DBS LD
Front panel Remote control
or

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha DSP-A2070 and is the answer not in the manual?

Yamaha DSP-A2070 Specifications

General IconGeneral
Number of Channels7
Total Harmonic Distortion0.015%
Damping Factor80
Digital InputsCoaxial, Optical
Video ConnectionsComposite, S-Video
Channel Separation60 dB
Speaker Load Impedance4 ohms to 16 ohms
Signal-to-Noise Ratio100dB (CD)

Related product manuals