RX-V340/RX-V340RDS/HTR-5630/HTR-5630RDS/DSP-AX340
25
RX-V340/RX-V340RDS/
HTR-5630/HTR-5630RDS/DSP-AX340
Sub-menu
CENTER SP REAR SP MAIN SP
MAIN LEVEL
LFE/BASS
1 MAIN: SMALL 0dB LARGE LARGE SMALL 0dB SWFR
2 CENTER: NONE NONE LARGE LARGE 0dB BOTH
3 LFE/BASS: MAIN SMALL SMALL LARGE 0dB MAIN
4 FRONT MIX: 5CH LARGE LARGE LARGE 0dB BOTH
5 REAR CENTER: POWER LARGE LARGE LARGE 0dB BOTH
(Not applied to these models.
4. SPEAKERS SET
The input signal is automatically identified and switched in
the priority order of dts → DOLBY DIGITAL → AAC →
PCM AUDIO → Analog (A/D) according to the signal
detection.
The signals output from the DSP block are the same as 1.
DSP THROUGH: YSS 0dB.
LARGE: This mode is used with a speaker with high
bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL: This mode is used with a speaker with low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE: This mode is used with no center speaker.
The center content is reduced by 3dB and
distributed to MAIN L/R.
The analog switch settings for each sub-menu are as
shown in the table below.
MAIN: SMALL 0dB LFE/BASS:MAIN
Front Mix: 5ch Rear Center power Tone Control Flat
Tone Control +10dB Tone Control –10dB
Not applied to these models.
4. SPEAKERSSET
Sub-menu
Treble Bass
6 Tone Control Flat 0 dB 0 dB
7 Tone Control +10dB +10 dB +10 dB
8 Tone Control –10dB –10 dB –10 dB
Neo:6
(Not applied to these models.)
Neo:6
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
