RX-V340/RX-V340RDS/
HTR-5630/HTR-5630RDS/DSP-AX340
RX-V340/RX-V340RDS/HTR-5630/HTR-5630RDS/DSP-AX340
28
8. MANUAL TEST
The noise generator built into the DSP outputs the test
noise through the channels specified by the sub-menu.
The noise frequency for LFE is 35 to 250 Hz. Other than
that, the center frequency is 800Hz.
TEST ALL TEST MAIN L TEST CENTER
TEST MAIN R
TEST REAR R TEST REAR CENTER
TEST REAR L
Noise is output from all channels.
Noise is output from the MAIN L channel.
Noise is output from the CENTER
channel.
Noise is output from the MAIN R channel.
Noise is output from the REAR L
channel.
TEST LFE
Noise is output from the SUB WOOFER
channel.
Noise is output from the REAR R channel.
Not applied to these models.
8.MANUALTEST
9. FACTORY PRESET
This menu is used to reserve and inhibit initialization of the
back-up RAM. The signals are processed using EFFECT
OFF. (The L/R signal is output using ANALOG MAIN
BYPASS.)
PRESET INHIBIT (Initialization inhibited) / PRESETINHIBIT
RAM initialization is not executed. Select this sub-menu to protect the values set by the user.
PRESET RESERVED (Initialization reserved) / PRESETRESERVED
Initialization of the back-up RAM is reserved. (Actually, initialization is executed the next time
that the power is turned on.) Select this sub-menu to reset to the original factory settings or to
reset the RAM.
CAUTION: Before setting to the PRESET RESERVED,
write down the existing preset memory
content of the Tuner in a table as shown
below. (This is because setting to the
PRESET RESERVED will cause the user
memory content to be erased.)
Preset group P1 P2 P3 P4 P5 P6 P7 P8
A
B
C
D
E
9.FACTORYPRESET
w
w
w
.
x
i
a
o
y
u
1
6
3
.
c
o
m
Q
Q
3
7
6
3
1
5
1
5
0
9
9
2
8
9
4
2
9
8
T
E
L
1
3
9
4
2
2
9
6
5
1
3
9
9
2
8
9
4
2
9
8
0
5
1
5
1
3
6
7
3
Q
Q
TEL 13942296513 QQ 376315150 892498299
TEL 13942296513 QQ 376315150 892498299
http://www.xiaoyu163.com
http://www.xiaoyu163.com
To Next Page
Loading...
Need help?
General