4-32
E
102025
EML42012
MOTOR EXTERIOR
EML42511
Cleaning the Outboard Motor
After use, wash the exterior of the out-
board with fresh water.
Flush the cooling system with fresh
water.
NOTE:
Refer to Flushing Cooling System instruc-
tions in “TRANSPORTING AND STORING
OUTBOARD MOTOR”.
EML42810
Checking Painted Surface of Motor
Check the motor for scratches, nicks, or
flaking paint. Areas with damaged paint
are more likely to corrode. If necessary,
clean and paint the areas. A touch-up
paint is available from a Yamaha dealer.
EML44010
COATING THE BOAT BOTTOM
A clean hull improves boat performance.
The boat bottom should be kept as clean
of marine growths as possible. If neces-
sary, the boat bottom can be coated with
an anti-fouling paint approved for your
area to inhibit marine growth.
Do not use anti-fouling paint which
includes copper or graphite. These paints
can cause more rapid engine corrosion.
66M-9-17-4 3/13/03 9:35 AM Page 33
To Next Page
Loading...
Need help?
General
