4-27
E
EML22110
Cleaning the Fuel Filter
1) Remove the screws holding the fuel
hose joint assembly . Pull the assem-
bly out of the tank.
2) Clean the filter (located on the end of
the suction pipe) in a suitable clean-
ing solvent. Allow the filter to dry.
3) Replace the gasket with a new one.
Reinstall the fuel hose joint assembly
and tighten the screws firmly.
604011
224012*
000606
EMU14622
INSPECTING AND REPLACING
ANODE(S)
Yamaha outboard motors are protected
from corrosion by sacrificial anodes.
Inspect the external anodes periodically.
Remove scales from the surfaces of the
anodes. Consult a Yamaha dealer for
replacement of external anodes.
cC
Do not paint anodes, as this would ren-
der them ineffective.
NOTE:
Inspect ground leads attached to external
anodes on equipped models. Consult a
Yamaha dealer for inspection and
replacement of internal anodes attached
to the power unit.
66M-9-17-4 3/13/03 9:35 AM Page 28
To Next Page
Loading...
Need help?
General
