2-5
EMU01294
Throttle Friction Adjusting Knob
A friction device in the tiller handle pro-
vides resistance to movement of the
throttle grip. This is adjustable for opera-
tor preference.
When constant speed is desired, tighten
the adjusting knob to maintain the
desired throttle setting.
w
Do not overtighten the friction adjusting
knob. If there is too much resistance, it
may be difficult to move the throttle grip,
which could result in an accident.
E
Resistance Knob
Increase Turn clockwise
Decrease Turn counterclockwise
506021
EMC27110*
Engine stop button
Pushing this button opens the ignition cir-
cuit and stops the engine.
EMC28210
Engine stop lanyard switch
The lock-plate on the end of the lanyard
must be attached to the engine stop
switch for the engine to run. The lanyard
should be attached to a secure place on
the operator’s clothing, or arm or leg.
Should the operator fall overboard or
leave the helm, the lanyard will pull out
the lock plate, stopping ignition to the
engine. This will prevent the boat from
running away under power.
66M-9-17-2 2/27/03 10:10 AM Page 6
To Next Page
Loading...
Need help?
General
