EasyManuals Logo

Yamaha Loopfactory AN200 User Manual

Yamaha Loopfactory AN200
147 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
51
Chapter 10 EG Basics
39 Going negative — with FEG Depth
As we promised in the last Tip, here’s a sound-creating pointer that takes advantage of the negative values of
FEG Depth. Try these settings out — and hear what it’s like on the “minus” side of the sound.
1 First, get everything set up with the following settings:
EG [SELECT]........... to “ALL” (both FEG and AEG)
[ATTACK] ................ to around 2:00 (90 - 100)
[DECAY].................. to around 1:00 (80)
[SUSTAIN] .............. to around 3:00 - 4:00 (100 - 120)
[RELEASE].............. to around 1:00 - 2:00 (80 - 90)
[CUTOFF] ................ to around 2:00 (100)
[RESONANCE] ........ to around 2:00 (70)
2 Finally, set the [FEG DEPTH] knob to 7:00 (-128) — the maximum negative
value.
3 Now, play several single notes, slightly apart, and listen for the very slow
attack and the long sustain. Hear how the filter slowly sweeps and grows
with the sound?
A negative FEG Depth setting reverses the FEG operation — producing a filter sweep effect that dips down
instead of peaks. This means the sound gets softer and more muffled, until the end — when the filter
sweeps back up again.
Try these, too
Experiment with higher Cutoff and Resonance settings than the ones shown above.
Adjust the FM Depth, Sync Pitch, and Noise Level settings — to give the Filter some richer
harmonics to work with, and make the sound more interesting.
For even greater degrees of weirdness, try some long Portamento settings, too (for example,
around 90 - 110).

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha Loopfactory AN200 and is the answer not in the manual?

Yamaha Loopfactory AN200 Specifications

General IconGeneral
BrandYamaha
ModelLoopfactory AN200
CategorySynthesizer
LanguageEnglish

Related product manuals