EasyManuals Logo

Yamaha Loopfactory AN200 User Manual

Yamaha Loopfactory AN200
147 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #87 background imageLoading...
Page #87 background image
87
Chapter 15 Song Recording
65 Adding Patterns to your Song — Insert Pattern
Naturally, you can add Patterns to your existing Songs — by using the Insert Pattern function. This puts a
new Pattern in the Song at the measure you specify.
It doesn’t matter whether you’re in the Song mode or the Song Edit mode — you can insert a Pattern from
either.
1 First, select the measure you want to insert the Pattern to, by holding
[SHIFT] and using the [OCT <<]/[OCT >>] buttons.
2 Call up the Insert Pattern function.
Hold down [SHIFT] and press [10] (INS/DEL PTN). You may have to press
the button more than once to call up the “inS” (Insert Pattern) display.
3 Next, select the Pattern you want to add to your Song.
Use the DATA knob.
4 Insert the selected Pattern.
The [10] button should be flashing. Press it once again (the button stops flashing and stays lit). At the
Y£n” (“Yes or no?”) prompt, press it a third time to actually insert the Pattern to the selected measure,
or press [EXIT] to cancel.
Take a look at the illustration below and see what happens when you insert a Pattern.
Don’t forget to store your newly edited Song, or you’ll lose any edits you’ve made once you turn the power
off or select another Song or Pattern.
Replacing a Pattern
If you want to replace a Pattern — in other words, erasing one and putting a new one in its
place — you’ll need to use Delete Pattern (page 88) to delete the Pattern first. Then, use Insert
Pattern to put the new one in.
Pattern 012
Measure 1
Pattern 012
Measure 2
Pattern 013
Measure 3
Pattern 014
Measure 4
Pattern 012
Measure 1
Pattern 012
Measure 2
Pattern 144
Measure 3
Pattern 144
Pattern 013
Measure 4
Pattern 014
Measure 5
Here, Pattern 144 is inserted to
Measure 3, and all following Pat-
terns are moved over to make
space for the new Pattern.
Insert Pattern
Allows you insert a Pattern to any measure
within an existing Song. All subsequent Pat-
terns/measures are displaced.
With Song (or Song Edit) mode active, hold
[SHIFT] and use [OCT <<]/[OCT >>] buttons
to select desired measure. Hold [SHIFT] and
press [10] to call up “inS” (Insert), select
the desired Pattern number with the DATA
knob, and press [10] twice to execute.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Yamaha Loopfactory AN200 and is the answer not in the manual?

Yamaha Loopfactory AN200 Specifications

General IconGeneral
BrandYamaha
ModelLoopfactory AN200
CategorySynthesizer
LanguageEnglish

Related product manuals