QL5/QL1
167
5) Executing updating
When the
[START]
button is pressed, a pop-up to confi rm
updating will appear.
While updating, use care so that no network disconnection
or QL power interruption occurs.
Pressing the
[OK]
button will start updating.
While updating, the screen display is as shown below
(“Updating (1/1)” is indicated in the Status column.)
6) Completion of updating
When updating is over, a popup confi rming it will appear.
Press the
[OK]
button, and the screen display will be as
shown below.
(“Update Done” is indicated in the Status column)
7) End of application
Press the X mark to end the application
• Updating Procedure
If an error message is indicated in the status column, do not
turn off the power switch of QL but execute the updating
procedure again.
To Next Page
Loading...
