Yamaha S08 - Multi Edit: Common and Part Parameters; Multi Edit Common Parameters; Multi Part Parameters

64
Basics Section Quick Guide Reference Appendix
18 SndVar → Rev Send Variation To Reverb Determines the send level of the signal sent from the Variation Effect to the Reverb Effect. 47 *20
19 SndVar → Cho Send Variation To Chorus Determines the send level of the signal sent from the Variation Effect to the Chorus Effect. 47 *20
20 MW VarCtl MW Variation Control Depth Each Variation Effect type has a specific fixed parameter that can be controlled in realtime with the MW
or AC1. (Refer to the Effect Parameter List in the separate Data List.)
37 *21
21 AC1VarCtl AC1 Variation Control Depth 37
Part...Settings of individual 16 parts
[MULTI] →→
→→
Multi Selection →→
→→
[EDIT] →→
→→
[+] or [-]
Settings...MIDI Data Table 2-8 in the separate Data List
VOICE
1Voice
Selection
Bank Select MSB/LSB, Program Number Assigns a Voice to each Part. 31 *22
MIX
2Volume Volume Adjusts the output level of each Part. 44
3Pan Pan Determines the Stereo Pan position. (Rnd: Pan position moves randomly each time a key is played) 28
4 -1/-2 NtLmt-L/H Note Limit Low/High Determines the lowest and highest notes of the keyboard range. 28
5 -1/-2 VelLmt-L/H Velocity Limit Low/High Determines the minimum and maximum values of the velocity range within which each Part will respond. 42
GENERAL
6 Rcv Ch MIDI Receive Channel Each Part receives MIDI messages according to the channel set here. Select “off” for Parts that you do not
want to respond to MIDI.
28 *23
7 -1/-2 NoteShift/
Detune
Note Shift/Detune For Note Shift: Determines the pitch (key transpose) setting in semitones (12: one octave). For Detune:
Determines the fine tuning.
*24
8 Mono/Poly Mono/Poly Selects whether each part is played back monophonically (single notes only) or polyphonically (multiple
simultaneous notes).
22
9Part Mode Part Mode Determines whether the Part uses Normal Voices (norm) or Drum Voices (drum). 22
TONE
10 -1 VelSnsDpt Velocity Sensitivity Depth Determines the velocity sensitivity , or how much the level of the voice changes in response to your
playing strength (velocity).
39 *1
-2 VelSnsOfs Velocity Sensitivity Offset Determines the amount by which received velocities are adjusted for the actual velocity effect. 39
11 -1 Cutoff Filter Cutoff Frequency Determines the cutoff frequency for the low pass filter. 43
-2 Resonance Filter Resonance Determines the amount of filter resonance or emphasis of the Cutoff Frequency. 43
12 -1 Attack Tm Attack Time Controls how the tone (filter) or volume (amplitude) changes from the moment a note is pressed on the
keyboard to the moment it is released, or the point at which the level has faded to zero.
*25
-2 Decay Tm Decay Time
-3 Releas Tm Release Time
Selected
by
Selected
by
Display Parameter Name Explanation
Related
Page
Multi Edit Common / Part