PREPARATIONS BEFORE USING THIS UNIT
4 En
PREPARATION
1 Connect the power cable to the wall
outlet.
2 Press ON/OFF to turn on the system.
y
• This unit has an auto off function, which will automatically
switch the system to off if the system is left turned on for 1 hour
without playback or any other operation being performed. This
function is not available when the source is set to DAB/FM.
• Press and hold ON/OFF on the top of the unit for more than 3
seconds to set the system to standby mode. All the information
on the front panel display is not displayed in standby mode.
This can reduce the power consumption. To cancel standby
mode, press ON/OFF.
• Even in system off/standby mode, the alarm function is
available.
• The memory back-up circuit prevents stored data such as the
time setting from being lost even in system off/standby mode.
The clock is not set at the factory.
1 Press CLOCK SET.
2 Select each setting with MENU S/T
and confirm with Center.
You can set YEAR → MONTH → DAY → TIME.
• This operation can be performed only with the remote control.
• Time appears in 12-hour notation (AM/PM), depending on the
model. For example, “4:00PM”.
• You can switch 12-hour/24-hour notation by pressing
FUNCTION → MENU S/T → Center to select TIME
FORMAT, then pressing MENU S/T → Center to select
12H/24H.
• The time settings are lost after one week when the power cable
is disconnected from the wall outlet.
Turning on/off the system
When the system is on: “Hello” appears, then clock and
other information are displayed.
When the system is off: “Good-bye” appears, then only
date and time are displayed.
Example: iPod playback mode display
Adjusting the clock
Notes
To Next Page
Loading...
Need help?
General
Weight and Dimensions
