Yamato DP23C User Manual

21
Operation Method
Auto Start Operation
3. Stop/terminate timer operation
• The operation starts automatically at setting time.
• Press the START/STOP key for one second to stop or terminate
operation. The screen returns to the initial setting screen.
To correct or check setting…
Changing the setting temperature or time during operation is possible by pressing the TIMER key. Use
the "▼▲" to change the setting value. Press the ENTER key respectively after changing the setting. They
are not changeable after the unit starts operation. In this case, stop the operation by pressing the
START/STOP key, then set the value again.
Press the "▼" to display the setting temperature, operation mode and residual time on the setting
temperature screen.

Yamato DP23C Specifications

General

Brand	Yamato
Model	DP23C
Category	Laboratory Equipment
Language	English