YAMAZAKI MAZAK INTEGREX i Series User Manual

MACHINING PROGRAM 4
4-57
2. P-codes for waiting
The execution of the commands for turret A will be stopped at the position of a waiting
P-code with some number until the program flow for turret B reaches a waiting P-code with
the same or a larger number.
Programming format
P; ( denotes a number from 1 to 99999999.)
Program structure
Operation
Note 1: A waiting P-code must be given in a single-command block. It may not function as
waiting command if it is entered in the same block together with other instructions.
Note 2: Use the waiting P-codes in the ascending order of their number, since one turret
cannot be released from the wait state until the program flow for the other turret
reaches a waiting P-code with the same or a larger number.
A
Upper turret
Lower turret
B
P100;
P10;
P10;
<A>
P200;
P3000;
<B>
C
P3000;






G109L1;
A
M30;
G109L2;
P10;
P100;
<A>
P200;
P3000;
P10;
C
B
M30;
P3000;
<B>
Commands for the upper turret
Commands for the lower turret
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK INTEGREX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	INTEGREX i Series
Category	Computer Hardware
Language	English