YAMAZAKI MAZAK INTEGREX i Series User Manual

4 MACHINING PROGRAM
4-12
Command for rotation speed
Command for Constant surface speed
R command
1. Spindle for speed clamping is to be set by address R.
R1: Turning spindle (see the figure below)
R2: Turning spindle (see the figure below)
R3: Milling spindle
D740PB006
Lower turret
Upper turret
R1
Turning spindle 2
Turning spindle 1
R2
R1
R2
G92S3000R1
G96S150R1M204
Rotational command
Maximum spindle speed is set to 3000 min
-1
.
Turning spindle1 is set to 150 m/min(reverse)
(In case of select
Turning spindle1 & Upper turret)
G97S12000M03
Rotational command
Rotation of the milling spindle at 1200 min
-1
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK INTEGREX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	INTEGREX i Series
Category	Computer Hardware
Language	English