YAMAZAKI MAZAK INTEGREX i Series User Manual

5 SUPPLEMENT
5-58
15. G-code (Group20)
A. Cross machining control axis
1. Command
Programming format
G110 Xx Zz Cc
Cancellation
G111
Function
Axis control of TR2 side by TR1 side or that of TR1 side by TR2 side is referred to as
cross machining control. Cross machining control axis is specified by G110 and G111.
Specify after G110 an axis address and the TR number controlling the axis.
Code value
Description
Unit
Setting range
Omit
x
X1: X-axis controlled by TR1 (Upper turret)
X2: X-axis controlled by TR2 (Lower turret)
1, 2
Possible
z
Z1: Z-axis controlled by TR1 (Upper turret)
Z2: Z-axis controlled by TR2 (Lower turret)
1, 2
Possible
c
C1: C-axis controlled by TR1 (Spindle 1 C-axis)
C2: C-axis controlled by TR2 (Spindle 2 C-axis)
1, 2
Possible
2. Sample
(Operation at TR1 side)
G110 X2
G00 X10. Z10.
G110 Z2
G00 X20. Z20.
G110 X1 Z1
G00 X30. Z30.
--- Changed to X-axis of TR2
--- X of TR2 moves to 10, Z of TR1 moves to 10.
--- Changed to Z-axis of TR2
--- X of TR2 moves to 20, Z of TR2 moves to 20.
--- Changed to X-axis and Z-axis of TR1
--- X of TR1 moves to 30, Z of TR1 moves to 30.
3. Notes
 As long as an axis in direct relation to tool movement is controlled for cross machining,
do not change tools (by M6).
 Synchronous feed with, or control of feed per, revolution of the milling spindle is not
available during cross machining control.
 The alarm CROSS MACHINING IMPOSSIBLE will be caused when a command for
cross machining control is given under one of the following incompatible modal
conditions.
 Nose radius/Tool radius compensation
 Polar coordinate interpolation
 Cylindrical interpolation
 Fixed cycle
 3-D coordinate conversion
 Tool tip point control
Serial No. 294060
Copyright (c) 2013 YAMAZAKI MAZAK CORPORATION. All rights reserved.
Serial No. 294060

YAMAZAKI MAZAK INTEGREX i Series Specifications

General

Brand	YAMAZAKI MAZAK
Model	INTEGREX i Series
Category	Computer Hardware
Language	English