Yanmar 2TNV70 - Starter Motor

STARTER MOTOR
10-8
TNV IDI Service Manual
Starter Motor
1–Nut
2 –Needle Bearing
3 –Pinion Housing
4 –Pinion Retaining Ring
5 –Pinion Stop
6 –Pinion
7–Shift Lever
8 –Solenoid Switch Assembly
9–Snap Ring
10 –Washer
11– Bushing
12– Intermediate Housing
13– Reduction Gear
14 –Washer
15– Through Bolt
16– End Housing
17– Brush Plate and Holder
18 – Field Assembly
19– Armature
20– Bushing
21 –Plate
22– Planetary Gear (3 used)
23 –Washer (3 used)
24– Pinion Shaft
STARTER MOTOR
WARNING
SHOCK HAZARD!
• Turn off the battery switch (if
equipped) or disconnect the
negative battery cable before
servicing the electrical system.
• Check the electrical harnesses for cracks,
abrasions, and damaged or corroded
connectors. ALWAYS keep the connectors
and terminals clean.
• Failure to comply could result in death or
serious injury.
Note: While starter motor design varies
between models, the basic repair
procedures are the same. The following
procedures are typical and may differ
from the starter being serviced.
TNV_IDI_ServiceManual_A4.book 8 ページ ２０１２年２月２４日 金曜日 午前１０時２４分