EasyManua.ls Logo

Yanmar 2TNV70 - After Initial 50 Hours of Operation

Yanmar 2TNV70
264 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PERIODIC MAINTENANCE
TNV IDI Service Manual
5-7
Periodic Maintenance Procedures
PERIODIC MAINTENANCE
PROCEDURES
Perform the following maintenance after the initial
50 hours of operation.
Replace Engine Oil and Engine Oil Filter
Check and Adjust Cooling Fan V-Belt
Replace Engine Oil and Engine Oil
Filter
WARNING
BURN HAZARD!
If you must drain the engine oil
while it is still hot, stay clear of
the hot engine oil to avoid being
burned.
ALWAYS wear eye protection.
Failure to comply could result in death or
serious injury.
NOTICE
Only use the engine oil specified. Other engine
oils may affect warranty coverage, cause internal
engine components to seize and / or shorten
engine life.
Prevent dirt and debris from contaminating the
engine oil. Carefully clean the oil cap / dipstick
and the surrounding area before you remove the
cap.
NEVER mix different types of engine oil. This may
adversely affect the lubricating properties of the
engine oil.
NEVER overfill. Overfilling may result in white
exhaust smoke, engine overspeed or internal
damage.
NOTICE
ALWAYS be environmentally
responsible.
Follow the guidelines of the EPA or other
governmental agencies for the proper disposal of
hazardous materials such as engine oil, diesel
fuel and engine coolant. Consult the local
authorities or reclamation facility.
NEVER dispose of hazardous materials
irresponsibly by dumping them into a sewer, on
the ground, or into ground water or waterways.
Failure to follow these procedures may seriously
harm the environment.
After Initial 50 Hours of Operation
TNV_IDI_ServiceManual_A4.book 7 ペー 122月4日 金曜 午1024

Table of Contents

Other manuals for Yanmar 2TNV70

Related product manuals