3. Operation
CD
Fresh water pump
@Altemator
CD
Stop solenoid
@
For fresh water
(4JH3E series
only)
24
@ For fresh water
® Fresh water tank
@ Flywheel housing
4.
Turn on battery switch and insert key
into key switch. Turn the key
to
the
ON
position.
5. Manual stop device
Pull the stop knob continuously while
cranking.
Electric stop device
Push the stop button on the instrument
panel continuously while cranking.
6.
When the key switch is turned, the
engine
will begin cranking. Continue
cranking for about 5 seconds, and
check for
abnormal noise during that
time. (If you remove your hand from the
stop knob or stop button
while crank-
ing, the engine
will start.)
3.2.6
Check and Resupply Lube Oil
and Cooling Water
When engine oil, clutch oil, or cooling
water is supplied for the first time
or
when
they must be
replaced, conduct a trial
operation
of
the engine for about 5
minutes and check the quantity of
lube oil
and cooling water. The trial engine oper-
ation
will send the lube oil and cooling
water
to
the parts, so the lube oil and
cooling water levels will drop. Check and
resupply as necessary.
1.
Supplying engine lube oil (See 3.2.2)
2.
Supplying marine gear lube oil
(See
3.2.3)
3.
Supplying cooling water
(See
3.2.4)
To Next Page
Loading...
