4. Maintenance & Inspection
4.4 EPA Requirements*
*(Applicable for the model 3JH3(C)E only)
4.4.1 EPA Certification Plate
This engine has the following EPA Certi-
fication
Plate attached:
• EPA Certification Plate
•
Attachment Position for Certification
EPA
certification plate
Plate
(attached to the top of the bonnet)
4.4.2 Conditions to
Insure Compliance
with Emission Standards
This product
is
an
EPA approved engine.
The following are the conditions that must
be
met
in
order to insure that the emission
during operation meets the EPA standards.
Be
sure to follow these.
• The surrounding conditions should
be
as follows:
a)
Ambient temperature: -20 - 40°C
b)
Relative humidity: 80% or lower
c)
Permissable value for intake negative
pressure:
0.5kPa (50mmAq) or lower
d)
Permissable value for exhaust back
pressure:
7.8kPa (800mmAq) or lower
•
The fuel and lube oil used should be
as
follows:
a)
Fuel: The diesel gas oil ISO 8217
40
DMA,
BS
2869 A 1 or
A2
(Cetane
No.
45
minimally.)
b)
Lube oil: Type API, class CD
•
Do
not remove the seals limiting the
amount of
fuel injected and the speed.
• Be sure to carry out inspections.
Follow the basic guidelines outlined
in
4.3 (Periodic Inspection Items) of this
manual and keep a record of the results.
Pay particular
attention to these
important points: replacing the lube oil,
lube oil filter, the fuel filter and cleaning
the intake silencer element.
Note: Inspections are divided into two
sections
in
accordance with whom
is
in
charge
of
carrying out the inspection: (the
User) and (the Maker).
To Next Page
Loading...
