3. Operation
NOTICE
If the cooling fresh water runs out
too often, or
only the cooling fresh
water
in
the fresh water tank
drops without any change
in
the
water
level of the subtank, there
may be some
leakage of water or
air.
In such cases, consult your
Yanmar
dealer or distributor with-
out
delay.
Note: The water rises
in
the subtank
during engine operation.
26
This is not abnormal. After stopping
the engine, the
cooling water cools
down and the extra water
in
the
subtank returns
to
the fresh water
tank.
(6)
Checking the Remote Control Handle
Be sure to check that the remote control
handle lever
moves smoothly before use. If
it is hard
to
operate, lubricate the joints of
the remote
control cable and also the lever
bearings.
If the lever comes out or there is play
in
the
lever, adjust the remote control cable.
(See
4.3.4
(3))
(7)
Checking the Alarm Devices Electric
Operation
When operating the key switch, check that
the
alarm devices work normally. (See
2.5.1
(3))
(8)
Preparing Fuel, Lube
Oil,
and Cooling
Fresh Water
in
Reserve
Prepare sufficient fuel for the day's
operation.
Always store lube oil and
cooling fresh water
in
reserve (for at least
one refill) onboard,
to
be ready for emer-
gencies.
3.3.2 How to Start the Engine
(1)
Start the engine according to the
following procedures:
Electric Operation
1.
Open the Kingston cock.
2.
Open the fuel tank cock.
3.
Set the remote control lever
in
NEUTRAL.
NOTICE
Safety equipment (optional) makes it
impossible to start the engine
in
any
other position than NEUTRAL.
To Next Page
Loading...
