3. Operation
(2)
If
antifreeze has
not
been added to the
cooling fresh water, be sure to drain
off
the
water from the fresh water cooling system
daily after
use.
Fresh Water Cooling
NOTICE
If the water
is
not removed, it may
freeze and damage parts of the
cooling water system (fresh water
cooler, cylinder block, cylinder
head, etc.) when ambient tempe-
rature is
below O°C.
1.
Open the water drain cocks
(3
positions
as
illustrated) and drain the cooling
water from inside.
2. With a screw driver, loosen the drain
plug attached
to
the lube oil filter
mount.
3. Close the drain cocks and the drain
plug after draining the water.
CD
For fresh water
(3JH3E series
only)
@
For fresh water
® For seawater
CD
Drain plug
(4JH3E series
only)
@Drain
plug
(3JH3E series
only)
CD
For fresh water
(3)
Carry
out
the next periodic inspection
before placing the engine in storage.
Clean the outside
of
the engine wiping
off
any dust
or
oil.
(4)
To
prevent condensation inside the fuel
tank, either drain
off
the fuel
or
fill the tank.
(5)
Grease the exposed area
and
joints
of
the remote control cable and the bearings
of
the remote control handle.
(6)
Cover the intake silencer, exhaust pipe,
etc. with vinyl sheets
and
seal them to
prevent moisture from entering.
(7)
Drain bilge in the hull bottom com-
pletely. Water may leak into the boat when
it
is moored, and whenever possible
it
should be landed.
(8)
Waterproof the engine room to prevent
rain and seawater from entering.
(9)
During long term storage, charge the
battery once
a month to compensate for
the battery's self-discharge.
31
To Next Page
Loading...
