YASKAWA E Series User Manual

8.2 Servomotor Main Circuit Cables
8.2.4 SGMCV Servomotor Main Circuit Cables
8
Cables and User-Assembled Wiring Materials for Direct Drive Servomotors
8-11
8.2.4 SGMCV Servomotor Main Circuit Cables
Selection Table
*1. Replace the boxes () in the order number with the cable length (03, 05, 10, 15, or 20).
*2. Use Flexible Cables for moving parts of machines, such as robots.
*3. The recommended bending radius (R) is 90 mm or larger.
Note: 1. Refer to the following section for information on connector specifications, manufacturers, and order num-
bers.
SGM7E Servomotors, SGM7F-
 A to -  D Servomotors, SGMCV Servomotors, and SGMCS Small-
Capacity, Coreless Servomotor on page 8-13
2. Refer to the following section for information on wiring material specifications and order numbers.
Main Circuit Cables for SGM7F-
 A to -  D Servomotors and SGMCV Servomotors on page 8-17
Wiring Specifications
Servomotor
Model
Flange
Specifi-
cation
Code
(6th
Digit in
Model
Number)
Length
(L)
Order Number
*1
Appearance
Standard Cable Flexible Cable
*2, *3
SGMCV-B
SGMCV-
C
SGMCV-
D
1
Non-
load side
installa-
tion
3 m,
5 m,
10 m,
15 m,
and
20 m
JZSP-CMM60-
-E
JZSP-C7MDN23-
-E
4
Non-
load side
installa-
tion (with
cable on
side)
JZSP-CMM00-
-E
JZSP-C7MDS23-
-E
L
Motor end
SERVOPACK end
L
Motor end
SERVOPACK end
Pin
Signal
Signal
Wire Color
1
2
3
4
Motor end
FG
Phase W
Phase V
Phase U
FG
Phase W
Phase V
Phase U
Green/(yellow)
Blue
White
Red
SERVOPACK end

YASKAWA E Series Specifications

General

Brand	YASKAWA
Model	E Series
Category	Servo Drives
Language	English