YASKAWA TM.iQp.02 iQpump Drive Programming Manual 117
■ o2-04 Drive / kVA Selection
Setting Range: 0 to FF
Factory Default: Model Dependent
Parameter o2-04 matches the control board to the iQpump drive hardware. Proper setting of o2-04 is important so that the control board
can provide proper protection for the iQpump drive hardware. This parameter is configured at the factory and does not normally require
adjustment in the field. It is available primarily to accommodate control board replacement in the event of damage.
Table 29 kVA Settings by iQpump Drive Model Number
The factory defaults of the following parameters may be changed when the setting of o2-04 is changed:
• b8-04 (Energy Saving Coefficient Value)
• C6-02 (Carrier Frequency Selection)
• E2-01 (Motor Rated Current)
• E2-03 (Motor No-Load Current)
• E2-05 (Motor Line-to-Line Resistance)
• L2-02 (MPL Ride-Thru Time)
• L2-03 (MPL Minimum Base Block Time)
• L2-04 (MPL Voltage Recovery Ramp Time)
• L8-02 (Overheat Pre-Alarm Level)
• L8-06 (Input Phase Loss Detection Level)
208-230/240 Vac 480 Vac
Model Number
Proper
o2-04 Setting
Model Number
Proper
o2-04 Setting
20P4 0 40P4 20
20P7 1 40P7 21
21P5 2 41P5 22
22P2 3 42P2 23
23P7 4 43P7 24
27P5 6 45P5 26
2011 7 47P5 27
2015 8 49P0 3C
2018 9 4011 28
2022 A 4015 29
2030 B 4018 2A
2037 C 4022 2B
2045 D 4024 3D
2055 E 4030 2C
2075 F 4037 2D
2090 10 4045 2E
2110 11 4055 2F
4075 30
4090 31
4110 32
4160 34
4185 35
4220 36
4300 37
To Next Page
Loading...
