YASKAWA L1000H - Keypad Operation

EN 17 YASKAWA Europe TOEP C710616 92D AC Drive L1000H Quick Start Guide
4 Keypad Operation
4 Keypad Operation
 Digital Operator and Keys
The digital operator is used to program the drive, to start and stop it, and to display
fault information. The LEDs indicate the operating status of the drive.
 Keys and Functions
Key Name Function
Function Key
(F1, F2)
The functions assigned to F1 and F2 vary depending on the menu that is currently displayed. The
name of each function appears in the lower half of the display window.
ESC Key
• Returns to the previous display.
• Moves the cursor one space to the left.
• Pressing and holding this button will return to the Speed Reference display.
RESET Key
• Moves the cursor to the right.
• Resets the drive to clear a fault situation.
RUN Key
The Run LED:
• is on, when the drive is operating the motor.
• flashes when decelerating to stop (“ramp to stop”), or when the speed reference is 0.
• flashes quickly when the drive is disabled by a DI, when the drive was stopped using an
Emergency Stop command via the digital inputs, or when an Up/Down command is active during
power up.
Up Arrow Key Scrolls up to display the next item, selects parameter numbers and increments setting values.
Down Arrow Key
Scrolls down to display the previous item, selects parameter numbers and decrements setting
values.
STOP Key Stops drive operation.
ENTER Key
• Enters parameter values and settings.
• Selects a menu item to move between displays.
LO/RE Selection
Key
Not used.
ALM LED Light
On: When the drive detects a fault.
Flashing:
• When an alarm occurs.
• When oPE is detected.
• When a fault or error occurs during Auto-Tuning.
LO
RE
F2F1
ESC
RUN STOP
ENTERRESET
ALM
DIGITAL OPERATOR JVOP-180
F1
F2
ESC
RESET
RUN
STOP
ENTER
LO
RE
ALM