YASKAWA L1000H - Ul Standards

11 UL Standards
YASKAWA Europe TOEP C710616 92D AC Drive L1000H Quick Start Guide 46
11 UL Standards
 Precautions for UL/cUL Standards Compliance
The UL/cUL mark applies to products in the United States and Canada. It indicates that UL has performed product
testing and evaluation, and determined that their stringent standards for product safety have been met. For a product to
receive UL certification, all components inside that product must also receive UL certification.
This drive is tested in accordance with UL standard UL508C and complies with UL requirements. To ensure continued
compliance when using this drive in combination with other equipment, meet the following conditions:
 Installation Area
Do not install the drive to an area greater than pollution severity degree 2 (UL standard).
 Ambient Temperature
IP20 enclosure: -10 to +50C
 Main Circuit Terminal Wiring
YASKAWA recommends using closed-loop crimp terminals on all drive models. UL/cUL approval requires the use of
UL Listed closed-loop crimp terminals when wiring the drive main circuit terminals on models CIMR-L40045 to
40150. Use only the tools recommended by the terminal manufacturer for crimping.
The wire gauges listed in the tables below are YASKAWA recommendations. Refer to local codes for proper wire gauge
selections.
Note: The mark indicates the terminals for protective ground connection. (as defined in IEC/EN 60417-5019)
Grounding impedance; 400 V: 10  or less
Three-Phase 400 V Class
Model
CIMR-L
Terminal
For Europe and China <1> For Asia <2> For U.S.A <3>
Screw
Size
Tightening
Torque
Nm (lb.in.)
Recommended
Gauge
mm
2
Applicable
Gauge
mm
2
Recommended
Gauge
mm
2
Applicable
Gauge
mm
2
Recommended
Gauge
AWG, kcmil
Applicable
Gauge
AWG, kcmil
40005
40006
R/L1, S/L2,
T/L3
2.5 2.5 to 6 2 2 to 5.5 14 14 to 10
M4
1.2 to 1.5
(10.6 to 13.3)
U/T1, V/T2,
W/T3
2.5 2.5 to 6 2 2 to 5.5 14 14 to 10
–, +1, +2 – 2.5 to 6 2 2 to 5.5 – 14 to 10
B1, B2 – 2.5 to 6 2 2 to 5.5 – 14 to 10
2.5 2.5 to 6 3.5 2 to 5.5 10 14 to 10
40009
R/L1, S/L2,
T/L3
2.5 2.5 to 6 2 2 to 5.5 12 14 to 10
M4
1.2 to 1.5
(10.6 to 13.3)
U/T1, V/T2,
W/T3
2.5 2.5 to 6 2 2 to 5.5 14 14 to 10
–, +1, +2 – 2.5 to 6 2 2 to 5.5 – 14 to 10
B1, B2 – 2.5 to 6 2 2 to 5.5 – 14 to 10
2.5 2.5 to 6 3.5 2 to 5.5 10 14 to 10