YASKAWA L1000H - Page 23

5 Start Up
YASKAWA Europe TOEP C710616 92D AC Drive L1000H Quick Start Guide EN 23
 Step 1: Basic Calculations - P4-01 = 1
Perform as following to provide the basic parameters:
• Enter the programming menu.
• Enter the pump parameter data as received with the valve package or calculated on the web page http://www.blain.de/
calc into P1- parameters.
•Set P4-01 = 1.
If teaching finished successfully, the display will first show “END” directly followed by “0”. Parameter P4-01 will be
reset to 0 automatically.
In case that the drive shows oPE12 alarm (ALM LED flashing), check and correct the P1 settings and repeat setting
P4-01 = 1.
The following table shows the data to be input:
* Only available when A1-01 = 2:
Teaching Mode Parameter Description Range/Unit
P1-01 Hydraulic Oil ISO VG Number
0: Manual Setting,
1: ISO VG 22,
2: ISO VG 32,
3: ISO VG 46,
4: ISO VG 68
0 to 4
P1-02* Temperature at 100 cSt Manual or preselected by P1-01 0 to 100 °C
P1-03* Temperature at 25 cSt Manual or preselected by P1-01 0 to 100 °C
P1-04 Ram Diameter Elevator data 10 to 1000 mm
P1-05 Number of rams Elevator data 1 to 10
P1-06 Suspension ratio Elevator data 1 to 10
P1-07 Empty car static pressure Elevator data 1 to 100 bar
P1-08 Pay load Elevator data 1 to 50000 kg
P1-09 Dynamic pressure increase Elevator data 1 to 30 bar
P1-11 Flow at 100cSt & at max. pressure
Pump data:
refer to the parameter data supplied with the valve
package or use the following web page to calculate
the values:
http://www.blain.de/calc
2.0 to 1600.0 l/min
P1-12 Flow at 25cSt & at max. pressure 2.0 to 1600.0 l/min
P1-13 Pump Rated Speed 500 to 4000.0 l/min
P1-14 Flow at empty car pressure & at 100cSt 2.0 to 1600.0 l/min
P1-15 Flow at 1 bar pressure & at 100cSt 2.0 to 1600.0 l/min
P1-16 Nominal Speed Elevator data 0.000 to 1.200 m/s
P1-17 Intermediate Speed Elevator data 0.000 to 1.200 m/s
P1-18 Inspection Speed Elevator data 0.000 to 0.300 m/s
P1-19 Leveling Speed Elevator data 0.000 to 0.150 m/s
YES
NO
Enter P1- parameters.
oPE12
alarm shown?
Set P4-01 = 1.
START
Finish