YASKAWA V1000 - Receiving

YASKAWA ELECTRIC TOBP C730600 60C V1000 Option SI-EN3/V Installation Manual 11
3 Receiving
3 Receiving
After receiving the option package:
1. Make sure that the option is not damaged and no parts are missing. Contact your sales
outlet if the option or other parts appear damaged.
NOTICE: Do not use damaged parts to connect the drive and the option. Failure to comply could damage
the drive and option.
2. Confirm that the model number on the option nameplate and the model listed in the
purchase order are the same. Refer to Figure 1 on page 12 for details. Contact the
distributor where the option was purchased or the Yaskawa sales office immediately about
any problems with the option.
u Contents and Packaging
Table 2 Option Package Contents
u Installation Tools
A Phillips screwdriver (M3, M3.5 to M6 metric or #1, #2 U.S. standard <1>) is required to
install the option.
Note: Tools required to prepare the option cables for wiring are not listed in this manual.
Description: Option Unit
Ground
Wire
Warning Labels Installation Manual
_
Quantity: 14 1 1
<1> Screw sizes vary by drive capacity. Select a screwdriver appropriate for the drive capacity.
MANUAL