EasyManua.ls Logo

Yealink SIP-T21 E2

Yealink SIP-T21 E2
1126 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Administrators Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
78
Procedure
LLDP can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Configure LLDP feature.
Parameters:
static.network.lldp.enable
static.network.lldp.packet_interval
Web User Interface
Configure LLDP feature.
Navigate to:
http://<phoneIPAddress>/servlet?p=
network-adv&q=load
Phone User Interface
Configure LLDP feature.
Details of Configuration Parameters:
Parameters
Permitted Values
Default
static.network.lldp.enable
0 or 1
1
Description:
Enables or disables the LLDP (Linker Layer Discovery Protocol) feature on the IP phone.
0-Disabled
1-Enabled
If it is set to 1 (Enabled), the IP phone will attempt to determine its VLAN ID through LLDP.
Note: If you change this parameter, the IP phone will reboot to make the change take
effect.
Web User Interface:
Network->Advanced->LLDP->Active
Phone User Interface:
Menu->Advanced (default password: admin) ->Network->LLDP->LLDP Status
static.network.lldp.packet_interval
Integer from 1 to
3600
60
Description:
Configures the interval (in seconds) for the IP phone to send the LLDP (Linker Layer
Discovery Protocol) request.
Note: It works only if the value of the parameter static.network.lldp.enable is set to 1
(Enabled). If you change this parameter, the IP phone will reboot to make the change take
effect.

Table of Contents

Other manuals for Yealink SIP-T21 E2

Related product manuals