Yealink SIP-T21 E2

Setting Up Your System
65
Configuring PC Port Mode
The PC port on the back of the IP phone is used to connect a PC. You can enable or disable the
PC port on the IP phones via web user interface or using configuration files. PC port is not
applicable to CP860/CP920 IP phones.
Procedure
PC port mode can be configured using the following methods.
Central Provisioning
(Configuration File)
<y0000000000xx>.cfg
Configure the PC port.
Parameter:
static.network.pc_port.enable
Web User Interface
Configure the PC port.
Navigate to:
http://<phoneIPAddress>/servlet?p
=network-pcport&q=load
Details of Configuration Parameter:
Parameter
Permitted Values
Default
static.network.pc_port.enable
0 or 1
1
Description:
Enables or disables the PC port.
0-Disabled
1-Auto Negotiation
Note: It is not applicable to CP860/CP920 IP phones. If you change this parameter, the IP
phone will reboot to make the change take effect.
Web User Interface:
Network->PC Port->PC Port Active
Phone User Interface:
None
To enable the PC port via web user interface:
1. Click on Network->PC Port.