5-Full Duplex 1000Mbps (only applicable to SIP-
T54S/T52S/T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones)
Note: It works only if the value of the parameter “static.network.pc_port.enable” is set to 1
(Auto Negotiation). It is not applicable to CP860/CP920 IP phones. For SIP-
T54S/T52S/T48G/T48S/T46G/T46S/T42G/T42S/T40G/T29G/T27G/T23G IP phones, you can
set the transmission speed to 1000Mbps/Auto Negotiation to transmit in 1000Mbps if the
IP phone is connected to the switch supports Gigabit Ethernet. We recommend that you do
not change this parameter. If you change this parameter, the IP phone will reboot to make
the change take effect.
Web User Interface:
Network->Advanced->Port Link->PC Port Link
Phone User Interface:
None
To configure the transmission methods of Ethernet ports via web user interface:
1. Click on Network->Advanced.
2. Select the desired value from the pull-down list of WAN Port Link.
3. Select the desired value from the pull-down list of PC Port Link.
4. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
5. Click OK to reboot the phone.
To Next Page
Loading...
Need help?
General