Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
96
To configure SLAAC feature via web user interface:
1. Click on Network->Advanced.
2. In the ICMPv6 Status block, select the desired value from the pull-down list of Active.
3. Click Confirm to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
4. Click OK to reboot the phone.
To configure IPv6 address assignment method via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port.
2. Press or to select IPv4 & IPv6 or IPv6 from the IP Mode field.
3. Press or to highlight IPv6 and then press the Enter soft key.
4. Press or , or the Switch soft key to desired IPv6 address assignment method
from the Type field.
If you select the Static IP, configure the IPv6 address and other network parameters in the
corresponding fields.
5. Press the Save soft key to accept the change.
A dialog box pops up to prompt that the settings will take effect after a reboot.
6. Click OK to reboot the phone.
To configure static DNS when DHCP is used via phone user interface:
1. Press Menu->Advanced (default password: admin) ->Network->WAN Port->IPv6.
2. Press or , or the Switch soft key to select the DHCP from the Type field.
3. Press or , or the Switch soft key to select Enabled from the Static DNS field.
4. Enter the desired value in the Pri.DNS and Sec.DNS field respectively.
To Next Page
Loading...
Need help?
General